Flowcrete Isocrete PHS
£120.00 – £255.00 exl. VAT
Per Unit
Description
- High speed installation, dramatically shortens overall programme
- Overnight cure for failed sand:cement screeds
- Dust free installations. No disruption or damage to other finishes.
- Impermeable to water
- Significantly exceeds BS8204 BRE test category A requirements for floor screeds
- Guaranteed to BRE Test Category A requirement for 15 years
- Solvent free
- Low odour
- Installed by approved applicators
You May Also Need...
Description
Flowcrete Isocrete PHS is a two-component, solvent-free, epoxy-based primer. The product has a low viscosity and good penetrative capacity.
PHS can be used to reinforce old porous concrete and acts as an injection plastic.
NOTE
When the Flowcrete Isocrete PHS Base is mixed with the Hardener a very exothermic reaction starts (i.e. much heat is generated). As with all epoxy resins, once mixed the PHS mix should always be used quickly to dissipate the heat of reaction. If the PHS mix is not applied within 10 – 20 minutes, a lot of black smoke will be generated
Additional information
| Size | 2.5Kg, 10Kg |
|---|
Brand
Flowcrete / Isocrete
Flowcrete has been at the forefront of resin flooring technology for over 30 years. Isocrete has been one of the most respected brands in floor screeding materials since the 1960s and was acquired by the Flowcrete Group in the 1990s. Today the group is one of the most respected flooring materials suppliers worldwide, with a huge range of screeds and coatings.
