Ronacrete Ronascreed Mortar – 25 Kg

£45.85 exl. VAT

Per Unit


SKU 1017894566213254 Category

Rapid strength gain low temperature mortar and fine concrete floor screeds.

  • Ready for foot traffic after 12 hours
  • Ready for vehicle traffic after 24 hours
  • Excellent wear resistance
  • Can receive floor coverings after 2-3 days

You May Also Need...

You may also like…


Ronascreed Mortar – High strength floor screed and repair mortar

Ronascreed Mortar – High strength floor screed and repair mortar. RonaScreed Mortar is a rapid strength gain mortar for laying floor screeds, repairing floor surfaces and rapid set bedding applications for bricks, blocks, kerbs and other compatible building components. RonaScreed Mortar is used where speed of strength gain and/or rapid reduction of residual moisture and humidity are of importance. Industrial, commercial and residential floors laid or repaired with RonaScreed Mortar can be fully trafficked as early as 12 hours after mixing. RonaScreed Mortar offers rapid strength gain and is capable of achieving 28 day strengths within 24 hours. RonaScreed Mortar may be applied at minimum temperatures of 0°C, permitting exterior application during cold weather and application in cold stores. For sub-zero repairs refer to RonaFloor Repair 1 Hour range.

Using Ronascreed Mortar – High strength floor screed and repair mortar


The substrate to which RonaScreed Mortar is to be bonded must be structurally sound and stable. Minimum compressive strength should be 25N/mm2 and minimum pull-off strength should be 1.5N/mm2. Surfaces should be vacuum shot blasted, planed or scabbled to expose aggregate, remove laitance and provide a mechanical key. All grease and oil must be removed. Dust, debris and loose material must be removed by vacuuming. Any defect or weakness in the substrate may result in failure of the topping or screed applied to it. The recommendations given in BS8204-3 section 7 should be followed, to assess the suitability of the substrate and ensure the performance of the topping. When repairing concrete with RonaScreed Mortar, repair perimeters must be saw cut and the concrete scabbled as required, to allow the minimum depth of mortar to be placed throughout.


The prepared surfaces must be thoroughly wetted with clean water. Very porous surfaces may require soaking for up to 24 hours. All surplus water must be removed before the primer is applied.


Brush apply a coat of Ronacrete Rapid Primer to the damp surface immediately before applying RonaScreed Mortar. Mix the primer thoroughly and apply evenly
over the surfaces ensuring total and uniform coverage taking care to avoid ponding. Only prime an area of floor which can be covered by the mortar within the working time of the primer. The coverage rate of Ronacrete Rapid Primer is 1.5-2m² per kg. Note that the primer must not be allowed to dry. Dry primer must be thoroughly abraded and reapplied.


RonaScreed Mortar must be mixed by forced action mixer (e.g. CreteAngle, Baron or similar) or high powered, slow speed drill and suitable spiral paddle (MR4 or similar) for approximately 3 minutes, shorter mixing times will not fully disperse the components and workability will be reduced. (continued) Free fall mixers must not be used. Once mixed the mortar should be used as quickly as possible.


Not quite what you’re looking for? Click here to browse more of our Ronacrete range.

Want to see how Ronascreed Mortar and other Ronacrete products have been used? Click here to view a range of Ronacrete Projects.



The Ronacrete group manufacture a comprehensive range of specialist materials for installation by expert contractors. For over 40 years, Ronacrete has been at the leading edge of product development and performance and across their six ranges, the company offer specialist solutions for a huge range of applications, from waterproofing and tanking to resin surfacing and specialist screed solutions.

Technical Information