Ronafix Prepacked Screed 25mm+ Ready to use mortar for laying floor screeds
Ronafix Prepacked Screed 25mm+ – Ready to use mortar for laying floor screeds. Ronafix Pre-packed Screeds are supplied as a pre-packed, ready to use mortar for laying floor screeds. They are supplied complete with all the correct components in one pack, together with a bottle of polymer gauging liquid. They are used with Ronacrete Standard Primer which gives monolithic adhesion to all correctly prepared surfaces. Ronafix Pre-packed Screeds are used to lay new screeds and toppings as thin as 6mm bonded or 35mm unbonded or floating. The cured mortar bonds securely to suitably prepared surfaces and is water resistant.
Ronafix Prepacked Screed 25mm+ Uses
Ronafix Pre-packed Screed 6-50mm
Screed or screed repair from 6-50mm
Ronafix Pre-packed Screed 25mm+
Screed or screeds repair from 25mm
Ronafix Pre-packed Wearing Screed 15-25mm
Granolithic Topping or repair from 15-25mm
Ronafix Wearing Screed 25mm+
Granolithic Topping or repair from 25mm
Ronafix Pre-packed Floating Screed 35mm+
Floating screed from 35mm
Ronafix Pre-packed Fine Concrete 25m+
Fine concrete screed from 26mm
Using Ronafix Prepacked Screed 25mm+ Ready to use mortar for laying floor screeds:
As soon as the mortar is mixed, it should be placed onto the wet/tacky primer, compacted, ruled and closed with a float or trowel. Avoid overworking the surfaces, this will increase the tackiness of the mortar. The float should be regularly washed, to prevent build up of polymer/cement paste. Ronafix Prepacked Wearing Screeds contain granite and may need to be polished and finished by final trowelling after placing.
Screeds and toppings with an overall thickness greater than the maximum depth per layer, 50mm approximately, must be placed monolithically (wet on wet) in more than one layer to ensure compaction. Each layer should be of approximately equal thickness and using the same mix design. To ensure satisfactory adhesion the lower layer(s) should be lightly combed, raked or roughened to provide a key for the next layer. Should intermediate layers dry, a priming coat must be applied between layers.
Joints should be formed in the floor screed/topping in line with expansion, contraction and movement joints and, on suspended floors, over support positions to accommodate movement. Isolation joints should also be placed around the perimeter of floor slabs and around columns, manholes and fixed bases. Joints should also be formed between any hot and cold areas of the floor. For further information refer to BS8204-3.
Not quite what you’re looking for? Click here to browse more of our Ronacrete range.
Want to see how Ronafix Prepacked Screed and other Ronacrete products have been used? Click here to view a range of Ronacrete Projects.