Adomast Safecure Super

£19.00£58.00 exl. VAT

Per Unit

Description

Adomast Safecure Super

• Retains over 90% of hydration water—tested in accordance with BS 7542 :1992
• Reduces surface shrinkage and cracking by controlling moisture loss from surfaces
• Increases water resistance
• Enables cement to hydrate more efficiently

You May Also Need...

Description

Adomast Safecure Super aqueous based 90% efficiency concrete curing compound applied to the surface of freshly laid concrete, Safecure Super physically ‘locks’ moisture into freshly cast concrete allowing full hydration of the cement thus allowing the concrete to fully cure. This is achieved by covering the surface of the concrete with a very thin temporary membrane that prevents moisture in the concrete from leaving the surface.

Benefits – reduced surface shrinkage and cracking, more durable hard wearing surface and prevention of dusting.

Safecure Super aqueous based 90% efficiency concrete curing compound is also available in a fugitive dye tinted form to assist visual indication during application

Applied to the surface of freshly laid concrete, safecure super physically ‘locks’ moisture into freshly cast concrete allowing full hydration of the cement thus ollowing the concrete to fully cure. This is achieved by covering the surface of the concrete with a very thin temporary mem- brane thot prevents moisture in the concrete from leaving the surface. Safecure Super has been tested, to show over 90% curing efficiency, when tested to BS 7542: 1992. Safecure Super is also a WRAS approved product.
Benefits of using include reduced surface shrinkage and cracking,; a more durable hard wearing surface and prevention of surface dusting.

Safecure super is spray applied to the surface of newly placed concrete. The concrete should be free from surface water and the nozzle of the spray should be held approx. 450mm from the concrete surface and passed back and forth to ensure complete coverage. The pump pressure should be maintained at a level producing a fine spray. Rate of application recommended at 4- 6m2 per litre.

Touch Dry Time: ‹1 to 3 hours dependent upon temperature and wind Hard Dry Time: 16 to 20 hours dependent upon temperature and wind

Apply the selected grade by spray at a rate of approximately 4-6 m2 per litre, taking care to ensure complete coverage. Immediately after use the spraying equipment, especially the spray nozzle, should be thoroughly washed out with clean and if possible warm water. This will help ensure the nozzle does not become blocked with dried polymer latex and affect subsequent spraying.

Additional information

Size

5L, 20L, 25L

Brand

Adomast

Adomast

Technical Information