Ronafloor Epoxy Floor Mortar – Floor screeds and floor repair mortar
Ronafloor Epoxy Floor Mortar – Floor screeds and floor repair mortar. RonaFloor Epoxy Floor Mortar Standard and Rapid are high performance epoxy resin mortars for repairing existing floors and providing new wearing surfaces in light and heavy traffic areas. Its formulation allows thin section application down to 5mm.
RonaFloor Epoxy Floor Mortar offers good mechanical resistance and will resist attack from most industrial chemicals including acids, alkalis, oils, fats, solvents and foodstuffs.
The rapid strength gain properties of RonaFloor Epoxy Floor Mortar Rapid shortens the pot life and working time of the mixed mortar. Whilst it is suitable for floor repairs its short pot life makes it unsuitable for laying floor screeds. Surfaces repaired with RonaFloor Epoxy Floor Mortar Rapid can be accessed by foot and heavy traffic after 4 hours (at 20°C).
Instructions for use of Ronafloor Epoxy Floor Mortar – Floor screeds and floor repair mortar
Add the total contents of Part B (hardener) to Part A (resin) and mix well. Apply at a coverage rate of 0.18kg/m2.
RonaFloor Epoxy Floor Mortar Standard and Rapid are supplied as a three component materials in a plastic container. Remove all materials from the container; pour the base and activator into the container and mix.
When thoroughly mixed slowly add the supplied aggregate and mix until homogeneous. The product has been designed to be used as a full pack; do not part mix.
Mix with a drill and paddle or similar. Mixing time should be approximately 3-4 minutes by machine and 5-6 minutes by hand. The Standard grade will have a pot life of approximately 30-45 minutes at 20°C; Rapid grade has a pot life of 15 minutes at 20°C.
Place the mixed material onto the wet primer. If the primer has dried it must be scabbled and reapplied. Spread and smooth the material with either a wood or steel float. Working the material will bring resin to the surface to allow it to be finished; avoid overworking the surface.
Day joints should be at 90° to the floor. Feather edging can be used at ramps and doorways etc but is not recommended for day joints. RonaFloor Epoxy Floor Mortar should not be used at temperatures lower than 10°C. Ideally store materials at 15°C to 20°C for 24 hours before use. Working time – Rapid grade Note that the working time of the Rapid grade is limited to only 15 minutes at a material, air and substrate temperature of 20oC (Standard 30 – 45 minutes) and within this time it must be transported to the point of application, laid and finished. After this time the mortar will lose workability.
RonaFloor Epoxy Floor Mortar Standard or Rapid can be used in most weather conditions and in a wide temperature range, typically from +5°C to 25°C The minimum working temperature is +5oC. Note that at high ambient temperatures the working time of the mix will be reduced; it will be increased at lower temperatures. Ideally store materials between 10oC and 20oC before use. In areas exposed to sunlight, the substrate can be hotter than the air and material temperature. Work must stop if material, air or substrate temperature exceeds 25oC.
Not quite what you’re looking for? Click here to browse more of our Ronacrete range.
Want to see how Ronafloor Epoxy Floor Mortar and other Ronacrete products have been used? Click here to view a range of Ronacrete Projects.