DCP Strongcoat Primer
DCP Strongcoat Primer is a two-pack solvent free, epoxy based primer for use with the Strongcoat and Griptop range of surface toppings.
Uses of DCP Strongcoat Primer
Strongcoat Primer can be used where the RH of the substrate is greater than 75%. Strongcoat Primer is applied by brush, roller or squeegee in one or two coats depending on the texture, porosity and evenness of the surface being primed.
Coverage – Approximately 4m²/kg at the specified coating thickness.
Important: This coverage figure is based on application to a smooth, dense surface. Coverage figures will vary according to the texture, porosity and evenness of the surface on which the Strongcoat Primer is being applied.
The surface must be clean, dry and free from dust, laitance, oils, paints or other forms of contamination.
Grit blasting can be used to remove laitance and surface contamination. For treatment of surfaces containing expansion joints consult our Technical Department.
Mixing – Taking care to ensure that the bottom and sides are thoroughly scraped, transfer the entire contents of the Strongcoat Primer Hardener container into the Resin container and, using a Jiffy-type mixer attached to a slow-running electric drill, mix for approximately two minutes.
Once mixing is complete, transfer the Strongcoat Primer to a roller tray and, using a medium-pile simulated sheepskin roller, apply it evenly over the surface.
*Important: Never mix Strongcoat Primer by hand as this could lead to areas of uncured material.*
Not quite what you’re looking for? Click here to browse more of our Don Construction Product range.
Want to learn more about Don Construction Products? Click here to view more information.